#USING FLDIGI ON KENWOOD D710 SERIAL#
I've also made sure that the software is setup to use the correct side of the radio for it's signal. Kenwood-Radios TM-D710-And-TM-V71 Messages Single 17694 Re: TM-D710/TM-V71 Re: Signalink Patrick Lang 11/09/15 17694 If you also hook up the serial port and put the rig in echolink sysop mode, then you can use rts to transmit. Looking for anyone with advise or actual experience setting up this radio for packet use with the internal TNC.Īnd yes I'm setting it for PACKET12 and the "D" is on showing that the TNC is turned on. Even then though I can't control the radio from N1MM. I know though that some communication though is going on because I can connect N1MM up and the it will read the frequency I'm tuned to and will respond when I change the frequency on the radio itself. My problem is that when either application goes to actually communicate with the TNC it says that the TNC is not found or is not responding. I’m trying to get my d710ga set up for fldigi for use in our areas emcomm group. I've tried a variety of the pre-programmed settings as well as some I found online. General Hey everyone New here, and fairly new to amateur radio (dec 2020).
I can not get FLDIGI or WinLink to open the TNC. I've tried three different USB to Serial converts and two different cables to the radio itself. I'm running into an issue though getting the TNC to respond properly. I got a second one though to use for Packet radio in my mobile go kit. Icom 705 2m digital modes Kenwood D700 and D710 for VHF FM. I've been using my 710G for APRS for a while now in my vehicle. Anan 7000DLE MK2 used for 160 through 6 m together with Thetis Kenwood TS-890S used for.
0 kommentar(er)
